Timer Operations, Sleep timer, Timer playback

TIMER OPERATIONS

7Press for gto select the source (CD, TAPE and TUNER), and press ENTER.

8Prepare the source. To play CD, load a disc.

To play a tape, insert a tape.

To play the radio, select the band and tune in the desired station.

9Press POWER 6STANDBY/ON (POWER) to turn the unit off.

"5" remains in the display to indicate the timer standby mode (when ECO mode is deactivated).

At timer-on time, the unit turns on and plays the selected source. After the specified timer-activated duration, the unit turns off again.

Turns off the unit automatically after a specified time.

Press SLEEP on the remote.

"SLEEP" flashes in the display.

With each press, the timer duration changes as follows:

OFF 10 MIN...70 MIN

If you set to "AUTO", the unit turns off automatically when the current CD or tape finishes playback or elapsed 100 minutes.

To check the remaining time until the unit turns off Press SLEEP on the remote. The remaining time is displayed for 6 seconds.

Press SLEEP on the remote repeatedly so that "OFF" is displayed.

Turns on the unit at a specified time for the specified duration. Make sure the clock is set correctly.

1Press VOLUME +, -to set the volume level.

2Hold down SHIFT and press TIMER on the remote repeatedly so that "5" and "PLAY" are displayed.

3Within 6 seconds, press ENTER. "ON TIME" is displayed.

4Press f or g to set the timer start hour, and press ENTER.

5Press for gto set the minute, and press

ENTER.

"OFF TIME" is displayed.

6Set the time to stop playback by following the same procedures as steps 4 and 5.

•To stop timer setting in steps 4 to 6, press CLEAR. Timer standby mode is also cancelled.

•The timer playback is not activated when the clock is not set. ("SET NG" is displayed.)

•Timer playback will not begin unless the unit is turned off first.

•Timer playback for AUX function is not possible.