Timer recording
Timer recording is available only for TUNER sources.
1Hold down SHIFT and press TIMER on the remote repeatedly so that "5" and "REC" are displayed.
2Within 6 seconds, press ENTER. "ON TIME" is displayed.
3Press f or g to set the timer start hour, and press ENTER.
4Press for gto set the minute, and press
ENTER.
"OFF TIME" is displayed.
5Set the time to stop recording by following the same procedures as steps 3 and 4.
6Select the band and tune in the desired station.
7Insert a recordable tape and then turn the unit off.
"5" and "REC" remains in the display to indicate the timer standby mode (when ECO mode is deactivated). At
•To stop timer setting in steps 1 to 4, press CLEAR. Timer standby mode is also cancelled.
•The timer recording is not activated when the clock is not set. ("SET NG" is displayed.)
•The timer recording will not begin unless the unit is turned off first.
To check the timer setting
Hold down SHIFT and press TIMER on the remote repeatedly so that "PLAY" or "REC" appears in the display.
The
To change the timer setting
Reset the timer again.
To cancel the timer
Hold down SHIFT and press TIMER on the remote repeatedly until "OFF" is displayed. "5" and "REC" disappear from the display.
Tip:
Your timer setting is retained even if the timer is cancelled. Next time the timer is activated, you can change your previous setting, or simply use the same setting again.
Notes
•The timer playback performs every day at the specified time unless you cancel it.
•You cannot set the same time for
•The timer playback will not begin unless the unit is turned off first.
17