Flute Fingerings | Akai Ewi4000s specification

FLUTE FINGERINGS

0

alt.

G

alt.

If any 1 or more of the K7, K8, or K9 keys are pressed, the note should stay.

alt.

This is the only non-flute fingering that flute players will need to get used to.

40

Image 42

Akai Ewi4000s manual Flute Fingerings

Contents

Reference Manual Page Important Safety Instructions Portable Cart Warning FCC Warning Table of Contents Features Introduction Parts & Functions TOP Panel Side / Rear Panel „ Program / Data Display Section „ Glide Plate Section „ Bend Plate Section „ Cable Clutch Section Power „ Using Battery Power„ AC adapter Connections „ Note Keys „ Octave Shift Rollers Basic OperationBasic Operation „ Grounding Plates „ Tonguing „ Mouthpiece„ Vibrato „ Pitch Bend Plates Adjusting the Sensitivity of the Sensors „ Hold Button and Octave Button „ Adjusting the Breath Sensor „ Adjusting the Pitch Bend Sensors „ Adjusting the Vibrato Sensor „ Adjusting the Glide Sensor „ Adjusting the Touch Sensors „ a Note About Adjusting Your Sensors Fingering Modes „ Selecting the Internal Sounds Program Key Internal SoundProgram KEY Functions „ Assigning a Program Number to a Note Key „ Setting Program Change Preferences „ Recalling the Program Number Assigned to a Note Key „ Program Up with the Hold Button „ Program Down with the Octave Button „ Adjusting the Volume of Each Program Adjusting the Volumes„ Adjusting the Main Volume „ Adjusting the Reverb Volume „ Adjusting the Reverb Effect Volume of Each Program „ Adjusting the Delay Effect Volume of Each Program„ Adjusting the Chorus Effect On/Off on Each Program Octave Button Functions „ Assigning Functions to the Octave Button Hold Button Functions „ Assigning Functions to the Hold Button „ Assigning Functions to the Pitch Bend Plates Pitch Bend Plate FunctionsGlide Plate Functions „ Assigning Functions to the Glide Plate Adjusting the KEY Delay „ Setting the Glide Effect Time & Rate Tuning Transpose Function Trans ButtonEditing the Internal Sound with Your Computer About Midi Transmitted Information from the EWI4000s Midi OUT„ Midi Program Change „ Changing the Midi Channel „ Changing the Breath Sensor Output „ Setting the Midi Velocity Value „ Changing the Vibrato Sensor Output to Another Midi Event „ Sending a Midi Panic Message to Reset All Controllers „ Setting the Hold Function Hold Button on Midi Transmit„ Setting the Glide Plate Function on Midi Transmit „ Sending an All Notes Off Message Restoring the Factory Presets Level master Level preset Reverb master „ The Right Hand Miscellaneous NotesEVI Fingerings „ The Left Hand Software Updating „ Basic EVI Fingerings Troubleshooting Fingering Charts Octave Shift Rollers EWI Fingerings Saxophone Fingerings Flute Fingerings Oboe Fingerings EVI Fingerings Midi Implementation Chart Transmit/Export Recognize/Import Remarks Menu Structure Octave Glide Parameter Range Defaults Update Control Protocol OFF Specifications Sound ModulePage