MAINTENANCE
HYDRO 88 & 96 03/09 Maintenance Section 5-10
©2009 Alamo Group Inc.
MAINTENANCE
General Information on Flail Mower Vibration
FLAIL MOWERS - INFORMATION BULLETIN NO. 5
Excessive Vibration
Vibration is a MONSTER and if allowed to continu e unchecked, can cause the complete break-u p of a machine
in a very short time.
A properly operated Flail Mower will produce very little vibration. If vibration does occur, the mower should be
stopped and the trouble corrected, as warranty does not cover failures resulting from continued
operation after something happens to cause the mower to vibrate excessively.
Vibration is caused by a ro t ating p art which is out o f balance. This coul d be the cutter sha f t or, on those models
having a universal slip join t as sem b ly driv e sh aft, from the dr ive sh aft.
If the two extreme ends of the drive shaft, (the splined yokes which fit on the tractor power take off shaft and
on the mower gear box driven shaft), are not parallel, vibration will be evident. This is because of the
mechanics of a universal drive wherein the rotational speed through a universal joint is not uniform. If the ends
of a universal drive shaft are parallel, the uneven rotation effect is cancelled out and the machine being driven
will be driven at a uniform rate of speed. However, if the ends are not parallel, the uneven rotation effect may
be multiplied, resulting in a speeding up and slowing down of the entire mower system (gear box, extension
shaft, pulleys, belt, and cutter shaft) each revolution. This effect can be readily noticed if the mower, while
running, is raised to an extreme height on the tractor lift.
For smoothest operation, the tilt of the mower shou ld be adjusted (on a 3-p oint hitch, by adju sting th e length of
the top link between the tracto r an d the mower ) so that the ends of the d rive shaft are p ar alle l when the mower
is down in operating position. Raising the mower while running, to extreme heights on the lift should be
avoided.
To check where the vibration is originating, first be sure the ends of the universal drive shaft are parallel. Then,
if vibration is still present, remove the drive belt and run the mower. If vibration is still present, it most likely is
coming from and caused by a bent drive shaft. If so, the shaft should be replaced or straightened. If the
vibration is gone - the drive portion of the mower is running smoothly - then the vibration is probably coming
from the cutter shaft (it could be a pulley out of balance or a faulty belt with a varying cross section, but this is
not likely).
The cutter shaft will run out of balance if:
1. Wire, rope, string, rags, etc., around the cutter shaft are holding the knives in a folded back
position. Remove such foreign objects and be sure all knives are free to swing to the extended
position.
2. Knives are missing or broken. Replace missing or broken knives.
3. Knife hanger lugs are broken off shaft. This condition usually results from continued operation in
contact with large hard objects where the knife hanger lugs themselves are hitting the hard objects.
Lugs should be replaced using arc welding equipment so as not to direct too much heat in one area of
the shaft.
4. Cutter shaft ball bearings are worn enough to have radial “play” in them. Replace ball bearing and
other worn parts to eliminate “play”.
5. Shaf t is bent. The shaf t s are straig ht within a couple of thousandths of an in ch whe n th ey are ma de. It
is possible that they will become bent in use, such as if the shaft is hooked on a stump while the tractor
is moving forward at good speed.
6. Shafts are operated at improper speed. Rotating shafts have what is known as a natural period of
vibration. The same is true of the cutter sha fts on the Flail Mowers.