Alcatel Carrier Internetworking Solutions omniswitch manual Prune bit is not pruning any

Using SNMPSNMP Overview

No.	Trap Name	Objects	Family	Description
22	dvmrpNeighborLoss	dvmrpInterface-	ipmr	A 2-way adjacency relationship
		LocalAddress		with a neighbor has been lost.
		dvmrpNeigh-		This trap is generated when the
		borState		neighbor state changes from
				“active” to “one-way,” “ignor-
				ing” or “down.” The trap is sent
				only when the switch has no
				other neighbors on the same
				interface with a lower IP address
				than itself.

dvmrpInterfaceLocalAddress—The IP address this system will use as a source address on this interface. On unnumbered interfaces, it must be the same value as dvmrpInterfaceLocalAddress for some interfaces on the system.

dvmrpNeighborState—State of the neighbor adjacency.

Note: This trap is not supported on OmniSwitch 6600 Family switches.

23 dvmrpNeighborNotPruning	dvmrpInterface- ipmr	A non-pruning neighbor has been
	LocalAddress	detected in an implementation-
	dvmrpNeigh-	dependent manner. This trap is
	borCapabili-	generated at most once per gen-
	ties	eration ID of the neighbor. For
		example, it should be generated
		at the time a neighbor is first
		heard from if the prune bit is not
		set. It should also be generated if
		the local system has the ability to
		tell that a neighbor which sets the
		prune bit is not pruning any
		branches over an extended period
		of time. The trap should be gen-
		erated if the router has no other
		neighbors on the same interface
		with a lower IP address than
		itself.

dvmrpInterfaceLocalAddress—The IP address this system will use as a source address on this interface. On unnumbered interfaces, it must be the same value as dvmrpInterfaceLocalAddress for some interfaces on the system.

dvmrpNeighborCapabilities—This object describes the neighboring router’s capabilities. The leaf bit indi- cates that the neighbor has only one interface with neighbors. The prune bit indicates that the neighbor supports pruning. The generationID bit indicates that the neighbor sends its generationID in Probe messages. The mtrace bit indicates that the neighbor can handle mtrace requests.

Note: This trap is not supported on OmniSwitch 6600 Family switches.

OmniSwitch 6600 Family Switch Management Guide March 2005 page 10-15