-12-
802756
© Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
To change the cycle after the first fill is complete
and before the first wash is complete:
1. Abort the current cycle by changing the cycle
selector knob to the OFF position.
2. Set the WASH/RINSE temperature selector.
3. Set cycle selector knob.
4. Turn on extra rinse, if desired.
5. Press and hold the START button for two
seconds.
To change the cycle after the first wash is
complete:
NOTE: This should only be done if the speed of the
final extract is incorrect for the fabric being
washed. For example, if washing delicate items on
the REGULAR cycle, the high speed extract may
damage the fabric. Or, if washing towels or jeans
on the HANDWASH/DELICATE cycle, the lower
speed extract would increase drying time.
1. Abort the current cycle by changing the cycle
selector switch to the OFF position.
2. Restart the cycle from the beginning. Refer to
the To Wash Cl oth es section.
To Pump Out Water After Aborting Cycle
Run a SPIN ONLY cycle. This cycle will perform a high
speed extract operation that will pump all of the
water out of the washer.
Manual Soaking
To soak a clothes load, start a wash in the desired
cycle. After fill is complete and wash drum has
started tumbling, turn the cycle selector knob to
OFF. When the clothes have soaked the desired
length of time, turn the cycle selector knob to the
cycle and press the start button to restart the
cycle.
DOOR Light
When the washer is started, the DOOR light will
come on after a short delay. The light will turn off
approximately 45 seconds after the cycle is
complete.
WASH Light
This light comes on during the wash part of each
cycle.
RINSE Light
This light comes on for the rinse portion of each
cycle.
FINAL SPIN Light
This light comes on while the wash load is in the final
spin of the cycle.
HEATING Light (Red Light – on select
models only)
This light comes on during the Boosted Hot setting
only. While the washer is heating, the HEATING light
will turn on.
Out of Balance Load
If at the end of the cycle, the load is dripping wet,
the washer has limited the spin speed. This is to
prevent damage to the unit if there is a severely
unbalanced load.
If this condition occurs, redistribute the load
manually and run a RINSE & SPIN cycle.
If the condition persists, consider steps discussed
in the Before Washing section.