Before You Start
Tools
For most installations, the basic tools you will need are:
12
3
5
4
D818I
1Wrench
2Screwdrivers
3Level
4Teflon Tape
5Duct Tape
Figure 1
NOTE: An 8 in. (20.32 cm) coin drawer is required for coin drop operated models.
WARNING
Any disassembly requiring the use of tools must be performed by a suitably qualified service person.
W299
Installing the Dryer
Step 1: Position and Level the Dryer
Install dryer before washer. This allows room for attaching exhaust duct.
Install the four rubber feet (in accessories bag).
Select a location with a solid floor. Dryers installed in residential garages must be elevated 18 inches (46 cm) above the floor.
Installation
No other fuel burning appliance should be installed in the same closet with the dryer.
The dryer must not be installed or stored in an area where it will be exposed to water and/or weather.
The dryer needs sufficient clearance and an adequate air supply for proper operation and ventilation, and for easier installation and servicing. (Minimum clearances are shown in Figure 2).
Place the dryer in position, and adjust the legs until the dryer is level from side to side and front to back. Leveling legs can be adjusted from inside the dryer with a 1/4 in. driver. All four legs must rest firmly on the floor so the weight of the dryer is evenly distributed. The dryer must not rock.
| 3 |
| 2 |
1 |
|
| 4 |
| DRY2234N |
| DRY2234N |
1 | Dryer Base |
2 | Leveling Leg |
3 | Level |
4 | Rubber Cup |
Figure 2
IMPORTANT: In mobile home installations, gas dryers MUST be permanently attached to the floor at the time of installation. Order No. 526P3 Hold Down Kit (available at extra cost) for a manufactured (mobile) home installation. Follow the instructions supplied with the kit.
Installation of unit must conform to the Manufactured Home Construction and Safety Standards, Title 24 CF4, Part
513220 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 7 |
