November 2006 | Connecting peripheral devices to the 201i server |
Completing the installation
Introduction
To complete the installation of the 201i server, lock the 201i into position. The server starts up automatically.
ATTENTION | When connecting the optional CLAN, do not power up |
| |
| unless your antivirus programs and Nortel security updates |
| are installed first. |
To complete the installation and start the 201i server
Note: Ensure that the switch in which the 201i is installed is powered on.
1Ensure that all peripheral devices are powered up (including the 201i shelf).
2Push the 201i server gently but firmly until it is flush with the backplane.
Result: The 201i server beeps for three seconds to indicate that power is being received.
3Close the lock latches to secure the 201i server to the backplane.
4Ensure that the power status LED is lit.
5Watch the HEX display on the 201i server.
The HEX display shows T:01 through T:08, and then HOST. This takes about 13 seconds.
201i Server Hardware Installation | 159 |
