November 2006 | Installing the 201i server in the Succession 1000 system |
Note: Alternate connection scenarios are supported, but are not depicted in this guide. If you want to use a connection scenario that is not described in this guide, ensure that you use appropriate cabling for each device.
Before you begin
1.Before you install the SCSI devices in a daisy chain, you must configure the SCSI device IDs and DIP switches. For instructions, see “Preparing peripheral devices,” on page 121.
To install the NTRH3502 cable
CAUTION
Risk of equipment damage
You must power off the 201i server before connecting or disconnecting SCSI cables.
1Remove the inner SCSI bracket from the inside of the Media Gateway or Media Gateway Expansion.
See the diagram on page 112.
201i Server Hardware Installation | 111 |
