Installing the 201i server in a large Meridian 1 system | Standard 1.07 |
ATTENTION |
| |
If you attempt to pull the connector off without | ||
| ||
| pressing the lock tab, you can pull the connector | |
| shroud off the backplane. If this happens, refer to | |
| the adjacent connectors for correct key positioning, | |
| and then replace the connector shroud. |
Remove the tie wraps where applicable to free the cable.
c.Remove the connector, I/O filter assembly, and all mounting hardware from the inside of the I/O panel so the slot is completely vacated.
Retain the mounting hardware (that is, screws, tie wrap base, standoffs, and so on). You will reuse this hardware to fasten the NTRH3501 cable.
4Repeat step 3 to remove the existing backplane cable for the right slot.
Store the cable, I/O filter assembly, and mounting hardware for this cable with your Meridian 1 spares. You will not use them with the 201i server.
60 | CallPilot |
