Preparing for installationStandard 1.07
Step | Description | Check | |
|
|
| |
9 | Connect the 201i server and devices as follows: |
| |
| Connect the monitor, keyboard, and mouse to the 201i | ❒ | |
|
| server faceplate (see page 142). |
|
| Connect the | ❒ | |
|
| intermediate SCSI cable (see page 144). |
|
| Connect the multi I/O cable to the ELAN and CLAN | ❒ | |
|
| network hubs (see page 153). |
|
|
| Note: If more than 3 m (10 ft) of multi I/O cable is |
|
|
| required, use the supplied |
|
|
| gender change jacks to attach additional cable. Up to |
|
|
| 76.2 m (250 ft) of cable length is supported. |
|
| Connect the modem to the multi I/O cable (maximum | ❒ | |
|
| length 15 m (50 ft) (see page 156). |
|
| Connect the power cords for all devices, and then power | ❒ | |
|
| them up. |
|
|
|
| |
10 | Complete the installation of the 201i server as follows: | ❒ | |
| | Connect the intermediate SCSI cable to the 201i server |
|
|
| faceplate. |
|
| | Close the lock latches on the 201i server. |
|
| | Boot the 201i server to the operating system. |
|
| See page 159. |
| |
|
|
| |
11 | Continue with the CallPilot <switch model> and CallPilot | ❒ | |
| Server Configuration guide for your switch and server. |
| |
|
|
|
|
40 | CallPilot |
