Alliance Laundry Systems Dryer Tumblers Electronic OPL Micro Control, H, L, P, S, U and Y Models with, OM Control Suffix, G and K Models with OM Control Suffix, RESET, Figure, Programming Manual

Electronic OPL Micro Control

H, L, P, S, U and Y Models with

OM Control Suffix

1.To use an Automatic Cycle, press an ON/ SELECT pad. Select HIGH, MEDIUM, MED LOW, LOW or NO HEAT for items that should not be dried with heat. A light to the left of the selected pad lights up.

To use a Time Dry or Custom Cycle, refer to the

Programming Manual.

ON / SELECT

HIGH

MEDIUM

MED LOW

LOW

NO HEAT

TMB1483N

Figure 8

NOTE: Do not press directly on lights or the center of pad. For proper selection, press on pad slightly to the right of center. Refer to Figure 9.

TMB806N

Figure 9

2. Press START pad to start tumbler.

START

TMB1485N

Figure 10

Installation/Operation Supplement

NOTE: All pads can be pressed in any sequence without damaging control or tumbler. To stop the tumbler at any time, open the door or press STOP/

RESET.

STOP/RESET

TMB1484N

Figure 11

NOTE: The window display will flash. Press STOP/ RESET twice (within 3 seconds) to end the cycle and reset the control to idle status. To restart the tumbler, CLOSE door and press START pad.

IMPORTANT: If the loading door or lint panel door is opened during the cycle, the heating system will shut off and the motor will stop. To restart the cycle, both doors must be closed and the PUSH TO START button must be pressed in.

3.When the cycle is complete, open door and remove the laundry.

G and K Models with OM Control Suffix

1.To use an Automatic Cycle, press a TEMPERATURE pad. Select HIGH, MED, LOW, DELICATE or NO HEAT for items that should not be dried with heat. A light to the left of the selected pad lights up.

To use a Time Dry or Custom Cycle, refer to the

Programming Manual.

TMB2201N

Figure 12

70392201 (EN)