Alliance Laundry Systems F232201R4 Pre-OperatingInstructions, Operating Instructions

Pre-Operating Instructions

1.Press and release emergency stop button to direct power to control module. Models with the rotation sensor will display WE-6 Firmware ID code HRWC18 and later or ARWCO1 and later. Machine must perform a speed test. For models without rotation sensor, proceed to step 1 of Operating Instructions.

2.Display shows size of machine and will flash “TEST?” and “SPEED” for 15 seconds.

3.Push Start keypad during the 15 seconds. Machine will test rotation sensing for 15 seconds.

4.Display will flash “POWER” and “WAIT” one time and will display “NEXT00.”

NOTE: If START is not pushed while display flashes “TEST?” and “SPEED” or if rotation sensing fails, then display flashes “POWER” and “WAIT” before showing “NEXT00” for approximately 2 minutes.

Operating Instructions

1.When display shows “NEXT00,” washer- extractor is ready to be loaded with laundry.

2.On UW35 – UW125 models, use left hand to press and hold the door unlock button located on the lower right front of the control panel. Refer to Figure 7.

UW35 – UW125 MODELS

MD003J

Figure 7

Operation

WARNING

Do not operate machine in a cycle with program keymode switch in program position. Program keymode switch must be in run position at all times, except when editing or programming cycle or setup information.

W528

WARNING

Do not operate machine in a cycle or if spinning with program keymode switch in program position.

W529

3.On UW35 – UW125 models, use right hand to turn door handle clockwise and swing the door left to open. Refer to Figure 8.

UW35 – UW125 MODELS

MD004J

Figure 8

F232201