1.Remove access cover from rear of dryer.
| D284IE0C |
2. Remove ground screw and | GROUND |
SCREW | |
save for use in Step 4. |
|
Remove wire and use in |
|
Step 5. |
|
D287IE0E
3. Use a strain relief
and insert end of | POWER | |
power cord | ||
CORD | ||
through power | GROUND | |
supply hole. | WIRE |
D288IE0D
4.Attach power cord ground (green) wire to rear bulkhead using ground screw removed in Step 2.
WHITE
NEUTRAL
TERMINAL
RED
GREEN
BLACK
D289IE0C
5.Use the three screws from the envelope located in the cylinder to attach the remaining power cord wires to the terminal block as follows:
a.Red wire to “L1” terminal.
b.Black wire to “L2” terminal.
c.White wire to Neutral terminal.
NOTE: When installing the white wire, loop the free eyelet end of the ground wire (removed in Step
2)and attach along with the white wire to the neutral (center) terminal on the terminal block.
6.Tighten all screws and reinstall access cover removed in Step 1.
14 | 504607 |