Electrical Requirements . . .

(Gas Dryers)

NOTE: The wiring diagram is located inside the control hood.

WARNING

To reduce the risk of fire, electric shock, serious injury or death, all wiring and grounding MUST conform with the latest edition of the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.1, and such local regulations as might apply. It is the customer’s responsibility to have the wiring and fuses checked by a qualified electrician to make sure your home has adequate electrical power to operate the dryer.

W113

DO NOT

OVERLOAD

CIRCUITS

DO NOT

USE AN

ADAPTER

DO NOT

USE AN

EXTENSION

Do not modify the plug provided with the dryer—if it will not fit the outlet, have a proper outlet installed by a qualified electrician.

WARNING

This dryer is equipped with a three-prong (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded three- prong receptacle. Do not cut or remove the grounding prong from this plug.

W036

STANDARD 120 VOLT, 15 AMP, 60 HERTZ, 3-WIRE

EFFECTIVELY GROUNDED CIRCUIT

“L1”

NEUTRAL

 

GROUND

115 ± 12

0

V.A.C.

V.A.C.

NEUTRAL

SIDE115 ± 12

V.A.C.

CORD

D009IE0C

ROUND

Grounding Instructions

The dryer must be grounded. In the event of malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for electric current. The dryer is equipped with a cord having an equipment-grounding conductor and a 3-prong grounding plug. The three-prong grounding plug on the power cord should be plugged directly into a polarized three-slot effectively grounded receptacle rated 110/120 Volts AC (alternating current) 15 Amps.

GROUNDING

PRONG

D090IE1E

NOTE: Have a qualified electrician check the polarity of the wall receptacle. If a voltage reading is measured other than that illustrated, the qualified electrician should correct the problem.

Do not operate other appliances on the same circuit when this appliance is operating.

WARNING

Improper connection of the equipment- grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service person if you are in doubt as to whether the dryer is properly grounded.

W038

WARNING

To reduce the risk of an electric shock or fire, DO NOT use an extension cord or an adapter to connect the dryer to the electrical power source.

W037

504607

15