Alliance Laundry Systems UW50P-4 14

Installation

0.75 in.

34.12 in.

0.75 in.

(19 mm)

(867 mm)

4.81 in.

(122 mm)

44.81 in.

in.

(1138 mm)

(229 mm)

1.25 in.

36 in.

(32 mm)

10.75 in.

39.25 in.

(914 mm)

(273 mm)

(997 mm)

34.56 in.

10.69 in.

(878 mm)

(271 mm)

FRONT

2 in.

0.75 in.

31.62 in.

(51 mm)

(803 mm)

2 in.

(19 mm)

(51 mm)

35.62 in.

(905 mm)

MOUNTING BOLT LAYOUT

PHM191N

Figure 3

PHM518N

X = 5 FEET

PHM518N

Figure 4

If the existing floor is not reinforced concrete a minimum of 12 inches thick over a solid base, it will be necessary to cut a hole through existing floor approximately 5 feet square and excavate to a depth of 36 inches from top of existing floor. Slope the edges of the hole outwards so that the hole is pyramid shaped. Excavate under existing floor 5 inches beyond the required 5 feet square all around. Refer to Figure 4 where x = 5 feet.

Refill with 24 inches of well compacted clean fill dirt topped with 12 inches of reinforced concrete. Imbed mounting bolts or base frame when pouring concrete. Make sure that the bolt threads extend 2 inches above the floor level.

After the foundation for the machine has been prepared and the concrete has cured, proceed as follows:

1.Place the machine adjacent to the foundation. Do not attempt to move the machine by pushing on the sides. Always use a pry bar or other device at the bottom of the machine. Remove the wood skid.

F232158