Allied Telesis AT-8000S - page 44

Page 44

Allied Telesis AT-8000SSwitch

Installation Guide

Warning

13. Do not strip more than the recommended amount of wire. Stripping more than the recommended

amount can create a safety hazard by leaving exposed wire on the terminal block after installation.

Warning

14. When installing this equipment, always ensure that the frame ground connection is installed first and

disconnected last.

Warning

15. Check to see if there are any exposed copper strands coming from the installed wire. When this

installation is done correctly there should be no exposed copper wire strands extending from the terminal

block. Any exposed wiring can conduct harmful levels of electricity to persons touching the wires.

Warning

17. This system works with positive grounded or negative grounded DC systems.

Warning

18. Only trained and qualified personnel are allowed to install or to replace this equipment.

Caution

19. The attached mounting brackets must be used to securely mount the device on the wall.

Caution

20. Do not install in direct sunlight, or a damp or dusty place.

Caution

21. Do not expose the gateway device to moisture or water.

Caution

22. If the gateway device is installed indoors, make sure that the site is a dust free environment. The site

should provide for easy access to the ports of the gateway device.This will make it easy for you to connect

and disconnect cables, as well as view the LEDs.

Contents

Main Page Table of Contents Page Page Preface How This Guide is Organized Document Conventions Contacting Allied Telesis Chapter 1. Product Description Features IEEE Standards AT-8000S/16 Front Panel AT-8000S/16 Back Panel AT-8000S/24 Front Panel AT-8000S/24 Back Panel AT-8000S/24POE Front Panel AT-8000S/24POE Back Panel AT-8000S/48 Front Panel AT-8000S/48 Back Panel AT-8000S/48POE Front Panel AT-8000S/48POE Back Panel Ports Description 10/100Base-T Fast Ethernet Ports 10/100/1000Base-T Uplink Ethernet Ports SFP Port DB-9 Console Port Mode LEDs Figure 11: Mode LEDs 24/48 Port Device Stacking LEDs Figure 12: Stacking LEDs Product Description Port LEDs 10/100 Base-T Fast Ethernet RJ-45 Port LEDs Figure 13: 10/100Base-T Fast Ethernet RJ-45 Port LEDs Allied Telesis AT-8000SSwitch 10/100/1000 Base-T/Combo Ethernet RJ-45 Port LEDs Figure 14: 10/100/1000 Base-T/Combo Ethernet RJ-45 Port LEDs Product Description 24/48 Port Device SFP/Combo Port LEDs Figure 15: SFP Port LEDs Allied Telesis AT-8000SSwitch 24/48 Port Device System LEDs Figure 16: SFP Port LEDs Power LED Diagnostic LED Stacking Ports LEDs Allied Telesis AT-8000S Switch Chapter 2. Installation Preparing for Installation Allied Telesis AT-8000S Switch Site Requirements Unpacking Package Contents Installing the Device Desktop or Shelf Installation Allied Telesis AT-8000S Switch Figure 18: Installing Rubber Feet Rack Installation Installation Figure 19: Attaching the Mounting Brackets Connecting the Device Connecting the Switch to a Terminal AC Power Connection Page Chapter 3. Stacking Understanding the Stack Topology Stacking Figure 20: Stacking Ring Topology Stacking Chain Topology Stacking Members and Unit ID Configuring Stacking Stacking Allied Telesis AT-8000SSwitch Chapter 4. Initial Configuration Configuration Overview Configuration User Name Chapter 5. Troubleshooting Page Appendix A. Technical Specifications Physical Specifications Weight Environmental Specifications Power Specifications Compliance Standards Cable, Port, and Pinout Information Pin Connections for the 10/100/1000 Ethernet Interface Page Page Appendix B. Safety Statements Laser Safety Notices Electrical Safety Notices Page Page Page Page Telecommunications Compliance Notices Index