Allied Telesis AT-8000S Rack Installation

Page 26

Allied Telesis AT-8000S Switch

Switch Installation Guide

Figure 18: Installing Rubber Feet

2. Set device down on a flat surface, while leaving 2 inches on each side and 5 inches at the back.

3. Ensure that the device has proper ventilation by allowing adequate space for ventilation between the device

and the objects around the device.

Rack Installation

The device can be mounted in an EIA standard-sized, 19-inch rack, which can be placed in a wiring closet with

other equipment. To install the device the mounting brackets must first be attached to the device’s sides.

Notes

• Disconnect all cables from the unit before mounting the device in a rack or cabinet.

• When mounting multiple devices into a rack, mount the devices from the bottom up.

To install the device in a rack, perform the following:

1. It is recommended to put on an ESD wrist strap and attach the ESD clip to a metal surface to act as ground.

An ESD strap is not supplied with the device.

2. Place the device on a flat and stable surface.

3. Place the supplied rack-mounting bracket on one side of the device ensuring the mounting holes on the

device line up to the mounting holes on the rack mounting bracket. The following figure illustrates where the

mounting brackets are placed on the device.

Contents

Main Page Table of Contents Page Page Preface How This Guide is Organized Document Conventions Contacting Allied Telesis Chapter 1. Product Description Features IEEE Standards AT-8000S/16 Front Panel AT-8000S/16 Back Panel AT-8000S/24 Front Panel AT-8000S/24 Back Panel AT-8000S/24POE Front Panel AT-8000S/24POE Back Panel AT-8000S/48 Front Panel AT-8000S/48 Back Panel AT-8000S/48POE Front Panel AT-8000S/48POE Back Panel Ports Description 10/100Base-T Fast Ethernet Ports 10/100/1000Base-T Uplink Ethernet Ports SFP Port DB-9 Console Port Mode LEDs Figure 11: Mode LEDs 24/48 Port Device Stacking LEDs Figure 12: Stacking LEDs Product Description Port LEDs 10/100 Base-T Fast Ethernet RJ-45 Port LEDs Figure 13: 10/100Base-T Fast Ethernet RJ-45 Port LEDs Allied Telesis AT-8000SSwitch 10/100/1000 Base-T/Combo Ethernet RJ-45 Port LEDs Figure 14: 10/100/1000 Base-T/Combo Ethernet RJ-45 Port LEDs Product Description 24/48 Port Device SFP/Combo Port LEDs Figure 15: SFP Port LEDs Allied Telesis AT-8000SSwitch 24/48 Port Device System LEDs Figure 16: SFP Port LEDs Power LED Diagnostic LED Stacking Ports LEDs Allied Telesis AT-8000S Switch Chapter 2. Installation Preparing for Installation Allied Telesis AT-8000S Switch Site Requirements Unpacking Package Contents Installing the Device Desktop or Shelf Installation Allied Telesis AT-8000S Switch Figure 18: Installing Rubber Feet Rack Installation Installation Figure 19: Attaching the Mounting Brackets Connecting the Device Connecting the Switch to a Terminal AC Power Connection Page Chapter 3. Stacking Understanding the Stack Topology Stacking Figure 20: Stacking Ring Topology Stacking Chain Topology Stacking Members and Unit ID Configuring Stacking Stacking Allied Telesis AT-8000SSwitch Chapter 4. Initial Configuration Configuration Overview Configuration User Name Chapter 5. Troubleshooting Page Appendix A. Technical Specifications Physical Specifications Weight Environmental Specifications Power Specifications Compliance Standards Cable, Port, and Pinout Information Pin Connections for the 10/100/1000 Ethernet Interface Page Page Appendix B. Safety Statements Laser Safety Notices Electrical Safety Notices Page Page Page Page Telecommunications Compliance Notices Index