Allied Telesis AT-GS950/48 manual Connecting Fiber Optic Cables

Connecting the

Fiber Optic

Cables

AT-GS950/48 Gigabit Ethernet WebSmart Switch Installation Guide

To connect a fiber optic cable to an SFP transceiver installed in the AT- GS950/48 Gigabit Ethernet Smart switch, perform the following procedure:

Note

If you plan to configure a redundant data path, make sure that the Spanning Tree feature is enabled via the AT-S106 Management Software before connecting the ethernet cables for your secondary network connections.

1.Remove the dust plug from the SFP transceiver, as shown in Figure 14.

1753

Figure 14. Removing the Dust Plug from the SFP

2. Connect the fiber optic cable to the SFP port, as shown in Figure 15.

1754

Figure 15. Connecting the Fiber Optic Cable

45