Manuals / Allied Telesis / Computer Equipment / Network Card

Allied Telesis AT-WCP200G manual Select Install Software. The menu below is displayed

Models: AT-WCP200G

1 40

Download 40 pages 58.98 Kb

Page 23

2.Select Install Software. The menu below is displayed.

AT-WCP200G User’s Guide

2.Select Install Software. The menu below is displayed.

3.Select AT-WCP200G Wireless PCI Adapter. The following InstallShield Wizard screen is displayed.

After the InstallShield Wizard is done preparing the installation, the following screen is displayed.

23

Image 23

Allied Telesis AT-WCP200G manual Select Install Software. The menu below is displayed

Contents

FOR WINDOWS 98/ME/XP/2000 VERSION User’s GuidePCI Adapter AT-WCP200GCopyright 2004 Allied Telesyn, Inc USA-FCC Wireless LAN Health and Authorization For UseRegulatory Notes and Statements Regulatory Information DisclaimersExport restrictions Safety InformationFCC Radio Frequency Exposure Statement FCC Interference Statement CE Mark Warning Protection Requirements for Health and Safety - Article 3.1aProtection Requirements for Health and Safety - Article 3.1b Effective Use of the Radio Spectrum - ArticlePage Table of Contents Page Preface How This Guide is Organized Document Conventions Preface Where to Find Related GuidesFor Sales or Corporate Information Obtaining Management Software Updates Tell Us What You ThinkContacting Allied Telesyn E-mail and Telephone Support Returning ProductsPage Introduction Allied Telesyn AT-WCP200G PCI AdapterOne AT-WCP200G PCI Adapter One CD-ROM This user’s guide Unpacking and SetupThis section provides unpacking and setup information for the AT-WCP200G adapterChecking the Installation Hardware InstallationFor Windows 98/ME/2000/XP Software InstallationInstalling the AT-WCP200G Driver AT-WCP200G User’s Guide 3. Select NextThe following screen will be displayed 4. Select Continued AnywayAT-WCP200G User’s Guide The following screen is displayedFor Windows 98/ME/2000/XP Installing the WIRELESS LAN Utility1. Insert the WIRELESS LAN CD into the CD-ROM Drive 2. Select Install Software. The menu below is displayed The following screen is displayed AT-WCP200G User’s Guide The following screen is displayedThe following screen is displayed 7. Select the country domain from the pull-down menu and then OK8. Select Yes from the following warning prompt Wireless Utility Setting Status Tab Configuration Tab Channel Advanced Tab Fragmentation Threshold Power Saving Select between OFF, Normal, or Maximum Transmit PowerAuthentication Mode Preamble TypeProfile Tab Network Tab Statistic Tab About Tab Physical and Environmental Technical SpecificationsGeneral Continuous Current 802.11b Regulatory DomainsRegulatory Domains Channel