action may decrease the rotation speed which reduces the efficiency of the grinder.
3.Hold the tool with both hands while starting; the torque from the motor will cause the tool to jerk.
4.When the grinding wheel first comes into contact with the work surface or when the wheel is new, make contact slowly.
5.Keep moving the tool in a circular motion to prevent grooving in the work surface.
6.Hold the unit tightly to prevent it from walking, and remove the high spots in the work surface from the top down.
HIGH-SPEED ANGLE GRINDER OPERATION
CAUTION!
Always be sure that the tool is switched off and unplugged before adjusting or checking function on tool. This tool is in accordance with IEC 60745, and it can be connected to electrical outlets without ground protection because of double installation. Radio suppres- sion complies with the international standard CISPR 14.
MAIN CONNECTION
Connect only to
SWITCHING ON AND OFF
CAUTION!
Before plugging in the tool, always check the working voltage be sure that the voltage specified is on the name plate. Before plugging in the tool, always check to see that the slide switch actuates properly and returns to the “OFF” position when the rear of the slide switch is depressed.
Switching on: |
|
Switch can be locked in “ ON” position for operator | ON POSITION |
comfort during extended use. Apply caution when |
|
the locking tool is in the “ON” position and maintain |
|
firm grasp on tool. |
|
Push sliding switch to the forward position and |
|
depress the front part of the switch to lock into |
|
position as shown in Figure 3. |
|
| |
| 11 |
