Alpha Tool.Com.HK Limited 225, hsg-125 instruction manual Assembling Spindle Attachments

ASSEMBLING SPINDLE ATTACHMENTS

CAUTION!

Do not leave threaded accessories on the spindle of the tool for extended periods of time, as this may result in making it difficult to remove these accessories.

Note: The Alpha® High-Speed Angle Grinder has a 5/8”-11 spindle thread . It comes with two Inside Flange and Locking Flange sets: 20mm Arbor for 4” discs and 7/8” Arbor for 4-1/2” to 5” discs.

To attach an approved spindle attachment to the tool, follow the steps below:

CAUTION!

Always disconnect the plug from the electrical outlet before carrying out any work on the machine.

1.Mount the inside flange. (use the 20mm Inside Flange and Locking Flange Set for 4” discs or the 7/8” Inside Flange and Locking Flange Set for 4-1/2”-5” discs).

Figure-9

2.Add the working tool and then the locking flange as shown in Figure 10 and 11.

Cutting Wheel in photo is not included.

Figure-10 Figure-11

15