Carbon Brush Holder Removal | Alpha Tool.Com.HK Limited hsg-125

Motor

Housing

Power Wire

Carbon Brush

Carbon Brush Assembly Parts

Coil

Spring

Carbon Brush Holder

Figure-18

CARBON BRUSH HOLDER REMOVAL

1.Disconnect the power wire from carbon brush holder.

Note: Each grinder has 2 carbon brushes located on opposite sides of each other.

Figure-19

2.Remove the carbon brush holder from the motor housing by pulling the holder out with a pair of needle nose pliers.

3.With the carbon brush holder removed, you can check and clean the armature commu- tator. The commutator is the contact points

that the carbon brushes ride on when the

motor is running. (See page 20 for cleaningFigure-20the commutator)

18

Image 18

Alpha Tool.Com.HK Limited hsg-125, 225 instruction manual Carbon Brush Holder Removal

Contents

Alpha High-Speed Angle Grinder Table of Contents Specifications HIGH-SPEED Angle Grinder Overview Accessories Components About the Symbols Introduction Personal Safety General Safety RulesElectrical Safety Work Area Service Tool USE and Care Specific Safety Rules USE Proper Extension Cords Additional Precautions for Using HIGH-SPEED Angle Grinder Safety Advice HOW to Grind HOW to Handle the Grinder Switching on and OFF HIGH-SPEED Angle Grinder OperationMain Connection Switching off Before USE About Double Insulation Laws and Regulations of Noise Levels Using the Tool Protective Cover Installation Assembling Spindle Attachments Disassembling Spindle Attachments Checking and Replacing the Carbon Brushes Rear Cover Removal Carbon Brush Holder Removal Carbon Brush Removal Cleaning the Commutator Installing the Carbon Brushes Alpha HIGH-SPEED Angle Grinder Schematic HSG-125 Alpha HIGH-SPEED Angle Grinder Parts List HSG-125 Only available with the HSG-125 Services and Warranty Information Need More Information WarrantyLoaner Program Alpha Tool Repair Service Company Headquarters EC Declaration of Conformity Electric Hand Tool Product Registration Card Bauer Drive, Oakland, NJ 07436 800-648-7229 Fax