overheating. Below table shows the correct size to use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the cord.
Ampere Rating | Total length of cord in feet (115V ) | ||||
25ft | 50ft | 100ft | |||
|
| ||||
More Than | Not More Than |
| AWG |
| |
0 | 6 | 18 | 16 | 16 | |
6 | 10 | 18 | 16 | 14 | |
10 | 12 | 16 | 16 | 14 | |
12 | 16 | 14 | 12 | Not Recommended | |
ADDITIONAL PRECAUTIONS FOR USING
THE HIGH-SPEED ANGLE GRINDER
In addition to the general safety notes described on the preceding pages, please read and observe the following precautionary notes before using the Angle Grinder.
DANGER!
SAFETY ADVICE
•Please note safety instructions on Page
•Do not pierce the motor housing as this could damage the double insulation.
•Always remove plug from the outlet before making any changes to the settings or performing maintenance.
•Ensure the tool is switched off prior to plugging in.
•Keep power cable clear from working area of the machine. The power cable should always lead away from you and behind the operating area.
•Before use, check the machine, cable and plug for any damages or material fatigue. Only authorized service agents should perform repairs.
•After switching off, the machine will not idle down immediately. Allow the machine to come to a complete stop before putting it down.
•Always wear safety glasses and ear protection when working with this machine. It is further recommended to wear safety gloves, apron, as well as sturdy
•Only use grinding discs whose permitted speed is at least as high as the highest no- load speed of the machine.
•Be sure wheels fit tool properly and securely. Do not modify the tool to force fit the wheel. Do not remove wheel cover.
9
