Antenna Receptacle
Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power antenna, if applicable.
•This lead should be used only for controlling the vehicle’s power antenna. Do not use this lead to turn on an amplifier or a signal processor, etc.
Remote Turn-On Lead (Blue/White)
Connect this lead to the remote
Audio Interrupt In Lead (Pink/Black)
Connect this lead to the Audio interface output of a cellular phone which provides ground shorting when a call is received.
Illumination Lead (Orange)
This lead may be connected to the vehicle’s instrument cluster illumination lead. This will allow the backlighting of this unit to dim whenever the vehicle’s lights are turned on.
Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle’s fuse box or another unused power source which provides (+)12V only when the ignition is turned on or in the accessory position.
Left Rear (+) Speaker Output Lead (Green)
Left Rear
Fuse Holder (10A)
Front Output RCA Connectors
RED is right and WHITE is left.
Rear/Subwoofer Output RCA Connectors
RED is right and WHITE is left.
MIC Input Connector
To Microphone.
RCA Extension Cable (sold separately)
Full Speed Connector
Control iPhone/iPod signals.
Connect this to an iPhone/iPod by using FULL SPEED Connection Cable
•Refer to “Setting the AUX+ SETUP Mode” (page 17).
AUX+ ON : When the external device is connected.
AUX+ OFF : When an iPhone/iPod is connected.
Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle’s battery.
Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle. Make sure the connection is made to bare metal and is securely fastened using the sheet metal screw provided.
Power Supply Connector
Right Front (+) Speaker Output Lead (Gray) Right Front
FULL SPEED Connection Cable
Front AUX Input Terminal
This terminal allows for input of audio from an external device (such as a portable player), using a commercially- available converter cable.
USB Connection Terminal
Connect USB memory (sold separately)
To prevent external noise from entering the audio system.
•Locate the unit and route the leads at least 10 cm away from the car harness.
•Keep the battery power leads as far away from other leads as possible.
•Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
•If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise suppressors, contact them for further information.
•Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
