Alpine CDA-9812RB, CDA-9812RR, CDA-9815RB, CDA-9813R, CDA-9811R owner manual Installation, 41-EN

Installation

Metal plate

Detachable

Front panel

Caution

When you install this unit in your car, do not remove the detachable front panel.

If the detachable front panel is removed during installation, you might press too hard and warp the metal plate that holds it in place.

Caution

Do not block the unit’s fan or heat sink, thus preventing air circulation. If blocked, heat will accumulate inside the unit and may cause a fire.

Air ventilation hole Air ventilation hole

(Rear of CDA-9812RX/CDA-	(Rear of CDA-9815RB/CDA-
9811R)	9813R)

1

	Rubber Cap
	(Included)
Bracket	Hex Bolt
	(Included)

Dashboard

Mounting sleeve (Included)

this unit

Slide mounting sleeve from main unit (see “Removal” on this page). Slide the mounting sleeve into the dashboard.

2	Metal Mounting Strap
	Screw

∗ Bolt Stud

Hex Nut (M5)

this unit

When your vehicle has the Bracket, mount the long hex bolt onto the rear panel of the CDA-9815RB/ CDA-9813R/CDA-9812RX/CDA-9811R and put the Rubber Cap on the hex bolt. If your vehicle does not have the Mounting Support, reinforce the head unit with the metal mounting strap (not supplied). Connect all the leads of the CDA-9815RB/CDA- 9813R/CDA-9812RX/CDA-9811R according to details described in the CONNECTION section.

•For the screw *, provide a proper screw to the chassis installing location.

3 Slide the CDA-9815RB/CDA-9813R/CDA-9812RX/ CDA-9811R into the dashboard. When the unit is in place, make sure the locking pins are fully seated in the down position. This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. Install the Detachable Front Panel.

Lock pin

Removal

1Remove the detachable front panel.

2Use a small screwdriver (or similar tool) to push the locking pins to the “up” position (see above drawing). As each pin is unlocked, gently pull out on the unit to make sure it does not re-lock before unlocking the second pin.

3Pull the unit out, keeping it unlocked as you do so.

<JAPANESE CAR>

Front frame

Screws (M5 ⋅ 8) (Included)

this unit

Mounting Bracket

41-EN