1Antenna Receptacle
2Audio Interrupt In Lead (Pink/Black)
Connect this lead to the Audio Interface output of a cellular phone which provides ground shorting when a call is received.
3Remote
Connect this lead to the remote
4Dimmer Lead (Orange) (CDA-9812RX only)
This lead may be connected to the vehicle’s instrument cluster illumination lead. This will enable the vehicle’s dimmer control to dim the backlighting of the unit.
5Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle’s fuse box or another unused power source which provides (+) 12V only when the ignition is turned on or in the accessory position.
6Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power antenna, if applicable.
•This lead should be used only for controlling the vehicle's power antenna. Do not use this lead to turn on an amplifier or a signal processor, etc.
7Choke Coil with Fuse Holder (20A)
8Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle's battery.
9ISO Power Supply Connector
!Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle. Make sure the connection is made to bare metal and is securely fastened using the sheet metal screw provided.
"Ai-NET Connector
Connect this to the output or input connector of other product (CD changer, Equalizer, etc.) equipped with Ai- NET.
#System Switch
When connecting a processor using
•Be sure to turn the power off to the unit before changing the switch position.
$ Power Supply Connector
%ISO Connector (Speaker Output)
&Left Rear (+) Speaker Output Lead (Green)
( Left Rear
~Left Front
+Right Front
,Right Front (+) Speaker Output Lead (Grey)
-Right Rear
. Right Rear (+) Speaker Output Lead (Violet)
/Remote Control Interface Connector
To remote control interface box.
:
;Front Output RCA Connectors
RED is right and WHITE is left.
<Rear Output RCA Connectors
RED is right and WHITE is left.
=Subwoofer Output RCA Connectors
RED is right and WHITE is left.
>RCA Extension Cable (Sold Separately)
To prevent noise/interference in the audio system.
•Locate the unit and route the leads at least 10 cm away from the car harness.
•Keep the battery power leads as far away from other leads as possible.
•Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
•If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise suppressors, contact them for further information.
•Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
