Getting Started
Initial System Start-Up
Be sure to press the RESET switch when using the unit for the first time, after installing the CD changer, after changing the car battery, etc.
SOURCE/ | Rotary |
| 1 |
|
POWER | encoder | Remote Sensor | Turn off the unit power. | |
|
|
| ||
|
|
| 2 | Remove the detachable front panel. |
|
|
| 3 | Press RESET with a |
|
|
|
| pointed object. |
MUTE | TITLE |
Controllable with Remote Control
This unit can be controlled with an optional Alpine remote control. For details, consult your Alpine dealer.
Point the optional remote control transmitter at the remote control sensor.
About the alphanumeric display of this unit
•All English lower case characters are displayed as upper case on this unit.
•The alphanumeric display in the following table shows alphanumeric characters/numbers that may be difficult to distinguish.
Alphanumeric | 0 | 2 | 5 | 6 | 8 | A | B | D |
|
|
|
|
|
|
|
|
|
Display |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Alphanumeric | G | H | K | M | Q | R | S | Z |
|
|
|
|
|
|
|
|
|
Display |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Turning Power On and Off
Press SOURCE/POWER to turn on the unit.
•The unit can be turned on by pressing any other button except eject c and TITLE .
Press and hold SOURCE/POWER for at least 2 seconds to turn off the unit.
• The first time power is turned on, the volume will start from level 12.
1
RESET switch
Setting Time
1In the Clock priority mode, press and hold TITLE for at least 2 seconds while the time is displayed.
The time indication will blink.
2Turn the Rotary encoder to adjust the hours while the time indication is blinking.
3When the hour has been adjusted, press the Rotary encoder.
4Turn the Rotary encoder to adjust the minutes while the time indication is blinking.
The time is automatically set 5 seconds after the minute adjustment. The time can also be manually set by pressing the Rotary encoder.
•To synchronize the clock to another clock/watch or radio time announcement, press and hold the Rotary encoder for at least 2 seconds after setting the “hour.” Minutes will reset to 00. If the display shows over “30” minutes when you do this, the time will advance one hour.
Adjusting Volume
Turn the Rotary encoder until the desired sound is obtained.
Lowering Volume Quickly
Activating the Audio Mute function will instantly lower the volume level by 20 dB.
Press MUTE to activate the MUTE mode.
The audio level will decrease by about 20 dB.
Pressing MUTE again will bring the audio back to its previous level.