Alpine ERE-G180 owner manual Operation, Turning Power On and Off, Adjusting the Subwoofer, Level

6

						Operation
				English/Français/Español		English
						Turning Power On and Off
						The ERE-G180 is turned on and off automati-
						cally when your head unit is switched on and
						off.
						Adjusting the Subwoofer
						Level
1	1					The ERE-G180 provides full user control of the
						subwoofer output. Not only can the output
						level be adjusted to +15 dB but frequency of
						the crossover point is continuously adjustable,
	2					input can be summed using the STEREO/
						MONO switch and a PHASE switch provides 0
						or 180° phase shift.
1					CROSSOVER	The LED on the SUBWOOFER LEVEL control
		PUSH			80Hz
						will be off when the SUBWOOFER ON/OFF
		SUB W.
						switch is in the "OFF" position. In this mode,
						the FRONT and REAR outputs will be full-
	50				120	range signals with no signal to the SUB-
						WOOFER output.
						The LED on the SUBWOOFER LEVEL control
					SUB W.	will illuminate in amber when the SUB-
	+15					WOOFER ON/OFF switch is in the "ON"
						position. In this mode, the FRONT and REAR
						outputs will be high-pass and the SUB-
						WOOFER output will receive the low-pass
	0					signals.
						Note: Push the SUBWOOFER ON/OFF switch
						to set the subwoofer mode to ON.
						Push the switch again to set the mode
						to OFF.
2					CROSSOVER	Select a crossover frequency between 50 and
					80Hz	120 Hz using the CROSSOVER
			PUSH
			SUB W.			FREQUENCY control.
	50				120