Phase Switching
1 Make sure that the defeat is turned off (page 25). 2 Press SETUP.
The SETUP selection screen is displayed.
3 Touch [ 
] of
The
4 Touch [ 
] of A.PROCESSOR.
The A.PROC list screen is displayed.
5 Touch [ 
] of PHASE.
The PHASE adjustment screen appears.
6 Switch the phase (0° or 180°) by touching [
] or [
] of the desired speaker.
7 Touch [RTN] to return to the previous screen.
Graphic Equalizer Adjustments
The graphic equalizer allows you to modify the sound using 31 bands each for the front (left and right), rear (left and right) and center speakers. An additional 10 bands are available for the subwoofer. This allows you to customize the sound to suit your taste.
1 Check that the Defeat mode is off.
2 Press SETUP.
The SETUP selection screen appears.
3 Touch [ 
] of
The
4 Touch [ 
] of A.PROCESSOR.
The A.PROC list screen appears.
5 Select L/R or L+R by touching [
] or [
] of G-EQ.
L/R: Different adjustment values can be set for the left and right channels.
L+R: Sets the same adjustment values for the left and right channels.
When parametric EQ is adjusted, this setting will be turned off.
6 Touch [ 
] of
The
7 Touch [ 
] of the desired speaker (channel).
The
8 Adjust the
Adjusting the Level
Touch [
] or [ 
] of the desired frequency to adjust the level.
9 Touch [RTN] to return to the previous screen.
•When the speaker is set to the “OFF” mode, the graphic equalizer for that speaker cannot be set. Refer to “Setting the Speakers” (page 41).
•Check the playable frequency ranges of the connected speakers before making the equalizer adjustments. If the speaker’s playable frequency range is 55 Hz to 30 kHz, for example, adjusting the 40 Hz or 20 Hz band has no effect. Additionally, you may overload and damage the speakers.
•When graphic EQ is adjusted, the adjustment for parametric EQ becomes ineffective.
Parametric Equalizer Adjustments
The frequency bands of the graphic equalizer are fixed. This makes it very difficult to correct for undesired peaks and dips at specific frequencies. The parametric equalizer’s center frequency can be tuned to these specific frequencies. Then, the bandwidth (Q) and level are
1 Check that Defeat mode is off.
2 Press SETUP.
The SETUP selection screen appears.
3 Touch [ 
] of
The
4 Touch [ 
] of A.PROCESSOR.
The A.PROC list screen appears.
5 Select L/R or L+R by touching [
] or [
] of P-EQ.
L/R: Different adjustment values can be set for the left and right channels.
L+R: Sets the same adjustment values for the left and right channels.
When graphic EQ is adjusted, this setting will be turned off.
6 Touch [ 
] of
The
7 Touch [ 
] of the desired speaker (channel).
The
8 Adjust the
Selecting the Band
Touch [
] or [ 
] of BAND.
Select the desired band.
Adjusting the Frequency
Touch [
] or [ 
] of FREQ., then adjust the frequency of the selected band.
Adjusting the Level
Touch [
] or [ 
] of LEVEL, then adjust the level of the selected band.
