Alpine TDA-7548E, TDA-7547E Turning Power, Non Fading Pre-Out, P. On and Off, NFP OFF NFP on

	English
	Basic Operation
1	Turning Power
	On and Off
1	Press the PWR button to turn on the unit.
	Note: The unit can be turned on by pressing
	any other button except the eject c and
	CLK buttons.
	PWR
	The volume level gradually increases to the
	previous level you were listening to before the
	unit was turned off. Press the PWR button
	again to turn off the unit.

	Non Fading Pre-Out
1	(N.F.P.) On and Off

1

NFP OFF

NFP ON

Press and hold the Eject button for at least 3 seconds.

With each press, N.F.P. is toggled On or Off.

N.F.P. ON: In this position, the Front Pre- Output on the TDA-7548E or Rear Output on the TDA-7547E will not be affected by the fader. This is ideal for driving a subwoofer amplifier.

N.F.P. OFF: Returns to normal fader mode.

Notes:

•Initial mode is "NFP OFF."

•Set the N.F.P. to OFF unless the subwoofer is used.

•If an optional Processor with subwoofer output is connected via the Ai-NET bus, this button will turn that output ON or OFF.

11