Getting Started
How to Install the AC Adapter
1Connect the AC adapter cable plug
into the speaker system’s jack.
The jack is located on the back of the system.
2 Plug the AC adapter into the wall outlet.
How to Install the Speaker Batteries
Your Altec Lansing Mix speaker system can also be powered by 8
1Make sure that there is no iPhone
or iPod in the system’s dock and that no other devices are connected to the system.
2 Unplug the AC adapter from the Mix speaker system.
3 Open the battery compartment.
The battery door is located on the
bottom of the Mix speaker system. To access it, place the unit on its back, so that the speakers are facing the ceiling. Then simply pull the tabs to open the battery compartment.
Caution: Do not place the unit on its top side. This may damage the volume knob.
4Install 8
Make sure the batteries are correctly installed as illustrated in the battery compartment. The batteries will provide up to 30 hours of
4continuous playing time.
5Replace the battery door.
NOTE Please discard used batteries properly.
NOTE When you are finished listening to your portable audio device, please remember to turn both it and your speaker system off to conserve electricity.
How to Install the
The
1Open the battery door.
The battery door is located on the back of the remote. Using your thumb, push the battery door toward the carabiner clip. Then lift the battery door open.
2Position the battery (included) so it sits in the battery holder correctly.
Make sure the polarity (the + and – sides of the battery) is correct.
3Replace the battery door.
NOTE Please discard used batteries properly.
