Altec Lansing IMT800 manual Setting EQ Controls, 1Enter the Graphic EQ Mode

Setting EQ Controls

NOTE You can personalize the EQ presets by selecting a Preset EQ then pressing the “EQ” button twice to enter the Bass/Treble Control Mode. There you can make adjustments to the Preset EQs as described in the Bass and Treble Control sections. Changes are saved automatically.

Note: To reset the EQ Presets to factory settings, press and hold the EQ button for a few seconds.

How to Adjust the 7-Band Graphic EQ Using the Onboard Controls

For even greater personalization of your music, you can dial in your sound with the onboard 7-band graphic EQ.

1Enter the Graphic EQ Mode.

Press and hold the “EQ” button while you press the or buttons.

2Select a frequency slider for adjustment.

Press the or buttons until the desired slider is highlighted.

3Increase or decrease the level of the frequency slider. Rotate the knob.

4Select the next frequency slider for adjustment.

Press the or buttons until the next desired slider is highlighted.

5Increase or decrease the level of the frequency slider. Rotate the knob.

6Continue selecting and adjusting frequency sliders as desired.

7Exit the Graphic EQ Mode.

Press the “EQ” button again. Or the unit will automatically exit this mode after several seconds.

Note: To reset the Graphic EQ to factory settings, press and hold the “EQ”

14button for a few seconds.

How to Adjust the 7-Band Graphic EQ Using the Clip-On Remote

1Enter the Graphic EQ Mode.

On the speaker system, press and hold the “EQ” button while you press the or buttons.

2Select a frequency slider to adjust.

Press the or buttons on the clip-on remote until the desired slider is highlighted.

3Increase or decrease the level of the frequency slider. Press the + or “–” buttons on the clip-on remote.

4Select the next frequency slider to adjust.

Press the or buttons on the clip-on remote until the next desired slider is highlighted.

5Increase or decrease the level of the frequency slider. Press the “+” or “–” buttons on the clip-on remote.

6Continue selecting and adjusting frequency sliders as desired.

7Exit the Graphic EQ Mode.

Press the “EQ” button on either the clip-on remote or the speaker system. Or the unit will automatically exit this mode after several seconds.

Note: To reset the Graphic EQ to factory settings, press and hold the “EQ” button for a few seconds.