MULTITASKER
Example 2:
The Key 8 label is SPEAKERS; it is set for volume control, and it is unlocked. The system will return the following:
KEY8= 8,108,0,0,0 SPEAKERS VOLUME
Example 3:
Display the contents of all the keys by sending {RDK*} and the system will display the key programs in the following format:
KEY 01: 000,000,000,000,000 LOCKED
KEY 02: 000,000,000,000,000 VOLUME
KEY 03: 000,000,000,000,000 VCR_ON
KEY 04: 000,000,000,000,000 VCR_OFF
KEY 05: 000,000,000,000,000
KEY 06: 000,000,000,000,000
KEY 07: 000,000,000,000,000
…
KEY 34: 000,000,000,000,000
KEY 35: 000,000,000,000,000
KEY 36: 000,000,000,000,000
NOTE: Unlike the subroutines, all key programs will be displayed even if they are not programmed. Keys that have not been programmed will be defined with all states equal to zero (000,000,000,000,000).
36.{WRK}
This command writes a key by assigning a subroutine ID to each of the 5 key states.
CAUTION: If programming Key 1 to perform functions from the front panel, remember SUB1 is a special case and is always performed on
A key may have up to five different states so it can be assigned to execute five different subroutines. The following table shows the state number and the condition a key must be in for the subroutine assigned to a particular state to be executed.
State | What to do when a key is pressed | |
and… | ||
|
1the LED is OFF
2the LED is ON
3the LED is FLASHING
4HELD for at least 2.5s
5HELD for 2.5s at
Format: {WRKn=s1,s2,s3,s4,s5}
Kn | = Key # (n = # from 1 to 36) |
s1 | = Sub ID (#0 to 180) for state 1 |
s2 | = Sub ID (#0 to 180) for state 2 |
s3 | = Sub ID (#0 to 180) for state 3 |
s4 | = Sub ID (#0 to 180) for state 4 |
s5 | = Sub ID (#0 to 180) for state 5 |
NOTE: Use subroutine zero if nothing should happen for a particular state. The key definition {WRK2=2,0,0,0,0} tells the controller to execute SUB2 if Key 2 is pressed when its LED is off and nothing for the remaining states.
Example: Key 6
{WRK6=10,20,30,40,0}
10 - State 1: Execute SUB10 when Key 6 is pressed and LED6 is OFF.
20 - State 2: Execute SUB20 when Key 6 is pressed and LED6 is ON.
30 - State 3: Execute SUB30 when Key 6 is pressed and LED6 is FLASHING.
40 - State 4: Execute SUB40 when Key 6 is PRESSED and HELD for 2.5s.
00 - State 5: Do nothing if Key 6 is PRESSED and HELD for 2.5s on
NOTE: If there are any discrepancies or if the buffer has not been initialized, the user will receive a message such as PLEASE PERFORM BUFFER TEST. Use the {TEST} command to initialize the buffer. Please refer to the {TEST} command for more information.
18 |
