MULTITASKER
GROUP OPERATION
This command enables one or all outputs for all cards in a group.
Command Format: [ONmGk]
m= Output number (m = # from
Turn on Output 1 for all cards in Group 1 by sending [ON1G1]. See the GROUP commands for a detailed explanation.
PATH OPERATION
The path for outputs on the same or multiple cards may be preloaded. This will set the path for the output, but it is not active until the switch command, [SW], is executed. Commands ending in “P” are not executed immediately.
Command Format: [ONmCnP]
m = Output No. (m = # from 1 to 8)
Cn = Card ID (n = slot # from 1 to max slots)
P= Path
Example:
An
C8 simultaneously by sending the following:
[ON1C4P]
[ON3C8P]
[SW]
16.[OFF]
This command disables one or all outputs of a single card or a group of cards.
SINGLE CARD OPERATION
Command Format: [OFFmCn]
m = Output No. (m = # from 1 to 8)
Cn = Card ID (n = # from 1 to max slots)
Example:
C4 has Output 1 turned on. The following commands may be used to turn off the input.
1) | [OFF1C4]: | Turn off only Output 1. |
2) | [OFFC4]: | Turn off all outputs. |
GROUP OPERATION
This command disables one or all outputs for all cards in a group.
Command Format: [OFFmGk]
m= Output No. (m = # from
Example:
1.[OFF1G1]: Turn off Output 1 for each card in Group 1.
2.[OFFG1]: Turn off all outputs for each card in Group 1.
PATH OPERATION
This command will set the path for the output, but it is not active until the switch command, [SW], is executed. Commands ending in "P" are not executed immediately. The path for outputs on multiple cards or the same card may be preloaded.
Command Format: [OFFmCnP]
m= Output (m = # from 1 to 8, * for all) Cn = Card ID (n = # from 1 to max slots) P = Path
Example:
There are two
8.Disable Output 1 of C4 and Output 3 of C8 simultaneously using the following commands:
[OFF1C4P]
[OFF3C8P]
[SW]
13 |