![29.[RUP]](/images/new-backgrounds/124697/12469733x1.webp)
MULTITASKER
{WRS8=RUPC4} | //Ramp Up |
{WRK8=8,108,0,0,0} | //Press= start, release= stop |
{WRS10=RDNC4} | //Ramp Down |
{WRK10=10,108,0,0,0} | //Press= start, release= stop |
{WRS108=RSTC4} | //STOP RAMPING |
{SETVK8} | //Set key 8 as volume key |
{WRLK8=VOL_UP} | //Define Key 8 Label |
{SETVK10} | //Set key 8 as volume key |
{WRLK10=VOL_DN} | //Define Key 8 Label |
[RAMP=10C4] | //Set the ramp rate. |
29.[RUP]
This command ramps the output volume to its maximum level at the rate defined using the [RAMP] command.
Command Format: [RUPCn]
Cn = Card ID (n = # from 1 to max slots)
Example:
Ramp the volume on Output 1 from 10 to the maximum of 32 for C4. Send the commands [SEL1C4] then [RUPC4] and the system will respond with the following feedback:
[11][12][13][14]…[32]
30.[RDN]
This command ramps the output volume down to a level of 00 at a rate defined using the [RAMP] command.
Command Format: [RDNCn]
Cn = Card ID (n = # from 1 to max slots)
Example:
Ramp the volume on Output 1 from a starting level of 32 down to 00 for C4. Send the commands [SEL1C4] then [RDNC4] and the system will respond with the following feedback:
[31][30][29]…[00]
31.[RUPm]
This command ramps up the volume for the specified output. The ramping continues to its maximum level at the rate defined using the [RAMP] command. The ramping may be stopped at any time using the [RST] command.
Command Format: [RUPmCn]
Cn = Card ID (n = # from 1 to max slots)
m= Output No. (n = # from 1 to 8) Example:
Ramp the volume for Output 2 from a starting level of 10 to the maximum level of 32 for C4. Send the command [RUP2C4] and the system will respond with the following feedback:
[11][12][13][14]…[32]
32.[RUPm=xx]
This command ramps a specified output’s volume to a user defined level at a rate defined using the [RAMP] command.
Command Format: [RUPm=xxCn]
m= Output No. (m = # from
Cn = Card ID (n = # from 1 to max slots) Example:
Ramp the volume on Output 7 from a starting level of 1 to a level of 20 for C4. Send the command [RUP7=20C4] and the system will respond with the following feedback:
[02][03][04]…[20]
33.[RDNm]
This command ramps down the volume for the specified output. The ramping continues to its minimum level at the rate defined using the [RAMP] command. The ramping may be stopped at any time using the [RST] command.
16 |
