OPE RATIO N - ELECT RONI C C ONT ROL
POWER INDICATOR LIGHT | LED DISPLAY |
HEAT INDICATOR
LIGHT
ON/OFF POWER KEY
LOCK INDICATOR
UP/DOWN
ARROWS
ON/OFF KEY
Press the on/off key once and the power indica tor light will illuminate. Press and hold the on/off key until the LED display turns off (at least three seconds) and on/off indica tor goes out.
UP/DOWN ARROW KEY
The up and down arrow keys are used for a variety of settings when selecting the holding temperature. If an arrow key is pressed and released the display will show the current set temperature for two seconds. If an arrow key is held (at least eight seconds), the value will change at a rapid rate. If the arrow key is pressed and released in rapid succession, the set temperature will change by increments of one degree.
ENABLE/D ISABLE BEEPER
A beeper sounds when an error code is displayed.
To choose between beeper on and beeper off mode, the control must be OFF, then press and hold the down arrow key until either "ON" or "OFF" is shown in the LED display. Release arrow key when desired mode is displayed.
°F/°C FAHRENHEI T / CELSIUS
With the control OFF, to choose between Fahrenheit and Celsius, press and hold the up arrow key until either °F or °C is shown in the LED display. Release key when desired setting is displayed.
The control has a
CONTROL LOCK
The warmer controls can be locked so that no changes can be made to the set temperature.
To lock the display , press and hold the ON/OFF key and the Up Arrow key at the same time. The lock indicator will illuminate. When the lock indicator is illuminated, additional programming will not be functional other than the key sequence required to unlock the panel.
To unlock the display, press and hold the ON/OFF key and the Down Arrow key at the same time. The lock indica tor will extinguish. The panel keys will resume normal function.
1.Preheat at 200°F (93°C) for 30 minute s.
Pre ss the ON key, and set | the temperatur e | ||
to 200°F (93C °) by using | the UP/DOWN | ||
arr ow keys . Allow a minim um of 30 | |||
min utes prehea ting | time befor e loa ding the | ||
draw er warmer with | food. The LED | hea t | |
indicator ligh t will go “OUT ” after |
| ||
approximat ely 30 minutes | pre heat tim e, or | ||
when the air temperatur e inside the | unit | ||
reaches the temperatur e set by the | operator. |
2.Load with pans of hot food only.
The purpose of the warmer is to maintain hot food at proper serving temper ature. Only hot food should be placed into the
unit . Before loading with food , use a food thermo met er to make certain all products are at an intern al temperature range of 140° to 160°F (60° to 71°C). Any food product not wit hin the proper temperatu re ran ge should be heated befor e loading into the unit .
3.Reset the con trol to 160°F (71° C) .
Check to make certain the drawer is
sec urely closed, and reset to 160°F (71° C) by using the UP/ DOWN keys .
THIS WILL NOT NECE SSARILY BE THE FINAL SETTI NG.
The proper temperatur e range will depend
on the type and qua ntity of product. | When | ||
holdin g food for prolonged periods , it is | |||
adv isable to periodically | check | the internal | |
temp erat ure of each item with | a food | ||
thermo met er to assure | mai nten ance | of the | |
proper temp eratur e range of |
|
| |
140° to 160°F (60° to 71°C). |
|
|
Dr awe r War mer Ins tallation/ Operation /S ervice Manual • 10.