Tilting Control Panel
Control panel can be adjusted to tilt from 0° to 12° to make more visible.
1.Loosen screws on top, and sides of control panel and pivot screw on bottom, sides of control panel before installing oven, or while oven partially pulled from opening.
2.Adjust control panel to desired angle and retighten screws.
0° tilt
Loosen screw
12° tilt
Pivot screw
Place Oven in Wall
This procedure should be performed by 2 people.
1.Seal Openings in wall behind the oven or on floor under oven. Holes must be sealed before sliding oven into position.
2.Lift wall oven and slide into cutout.
3.Secure wall oven to cabinet with 4 screws.
Place Oven in Wall
Tilt Control Panel
Removal and Reinstallation of Oven
1. Disconnect power to oven at circuit breaker or fuse panel.
2. Remove screws securing oven to wall.
3. Remove oven and place oven aside.
4. Disconnect electrical conduit.
5. To reinstall oven, follow instructions in Installation section of this manual.
9
