Converting Oven Burner for Use with LP\Propane
1.Remove storage drawer.
•See Removing Storage Drawer section.
2.Locate and remove 2 screws attaching
•Cover plate located in center, rear of storage drawer cavity.
•Removing cover plate exposes oven burner orifice and air shutter.
3.Turn orifice hood clockwise until snug.
•Do not overtighten orifice hoods. Orifice hoods can strip.
4.Replace cover plate and storage drawer.
with 5/16 inch socket wrench and replace with LP/ propane burner spud stamped “58”.
•Attach unused burner spud near regulator for future use.
5.Reinstall broiler and, if necessary, oven door.
B
A
C
C
A |
B |
Converting Oven Burner
Converting Broiler Burner for Use with LP\Propane
1.Locate orifice spud attached adjacent to pressure regulator and remove for later use.
•Orifice spud used for LP/propane gas is silver and is stamped “58”.
2.Open oven door and locate broiler burner on oven ceiling.
•Remove oven door to make conversion easier. See Removing Oven Door section.
3.Remove 2 screws securing front of burner to oven ceiling and remove broiler.
•Be careful not to damage ignitor while removing broiler.
4.Unscrew natural gas burner spud stamped “52”
Converting Broiler Burner
Converting Type 1 Pressure Regulator for Use with Natural Gas
1.Remove pressure regulator cap with a wrench.
2.Remove plastic insert from pressure regulator cap.
•Plastic insert fits tightly in cap.
3.Reverse plastic insert and carefully push plastic insert firmly into hole in pressure regulator cap.
•Insert must show “NAT” or be blank.
4.Place pressure regulator cap on pressure regulator and tighten.
•Insert should not disturb spring in body of regulator.
Converting Type 2 Pressure Regulator for Use with Natural Gas
1.Remove pressure regulator cap with a wrench.
2.Reverse pressure regulator cap.
• Insert shows “NAT” or is blank.
3.Place pressure regulator cap on pressure regulator and tighten.
10
