A
C
B
D
E
A. | “P” clamp | B. | Copper tubing |
C. | Brass nut | D. | Brass sleeve |
E.Water valve inlet connection Water supply line connection
2.Turn on water supply to refrigerator and check for leaks. Correct any leaks.
3.Create service loop using extreme care to avoid kinks. Secure copper tubing to refrigerator cabinet with a “P” clamp.
4.Plug in power cord.
5.Move refrigerator into final location.
6.Stabilize refrigerator and align doors.
If refrigerator rocks or is not stable on floor perform the following:
•Determine which rear corner is rocking.
•Remove toe grille to gain access to roller adjustment screws.
•Turn rear roller adjustment screw clockwise to raise corner that is rocking.
B
A
C
A.Rear roller adjustment screw
B.Door hinge screws
C.Front roller adjustment screw
Stabilizing refrigerator
•Check alignment of top of doors. If doors are level replace toe grille.
If tops of doors are not level perform the following steps:
•Determine which door must be raised (if toe grille has not been removed, remove at this time).
•Turn front roller adjustment screw clockwise to raise front corner of door that needs to be raised. Roller adjustment screw should be turned until doors are level.
•Replace toe grille.
B |
A |
A.Turn roller adjustment screw clockwise to raise door.
B.Continue to turn screw clockwise until doors are level.
Leveling doors
7.Review “Installation Checklist” in Owner’s Manual with consumer.
5
