Amana XRSS287BB, XRSS287BW manual How to Remove and Replace Light Bulbs, How to Get the $ Most Out

Models: XRSS287BB XRSS287BW

1 280
Download 280 pages 29.59 Kb
Page 17
Image 17

How to Remove and Replace Light Bulbs

!WARNING

To avoid electrical shock which can cause severe personal injury or death, disconnect power to refrigerator before replacing light bulb. After replacing light bulb, connect power.

!CAUTION

To avoid personal injury or property damage, observe the following:

Allow light bulb to cool.

Wear gloves when replacing light bulb.

Upper fresh food section

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1.

Locate finger gaps on each side of clear light

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

shield. Insert fingers and press in on each side

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

of shield. Pull shield down and remove.

 

 

 

 

2.

Remove light bulbs.

 

 

 

 

 

 

 

 

 

 

 

3.

Replace with appliance bulbs no greater than

 

 

 

 

 

 

 

 

 

 

 

 

25 watts.

 

 

 

 

4.

Replace light bulb cover by inserting front tabs of

 

 

 

 

 

light shield into holes in liner directly in front of light assembly.

$%

 

Lower fresh food section and

Non-dispensing model freezer section

1. Pinch bottom tabs (A) on light cover and pull straight out.

2. Remove light bulb.

3. Replace bulb with appliance bulb no greater than 25 watts.

4.Insert top tabs (B) of light cover into refrigerator liner and snap bottom portion over light assembly.

Dispensing model freezer section

1.

Remove ice bin by lifting front of bin and pulling out.

 

A

2.

Remove light bulb cover by pinching top tab (A) and

 

 

 

pulling cover out of liner.

 

 

 

 

 

3.

Remove light bulb. Replace with appliance bulb

 

 

 

no greater than 25 watts.

 

 

4.

Insert bottom tab (B) of light cover into liner and snap

 

B

 

top portion over light assembly.

 

 

 

 

5.

Replace ice bin by sliding in until bin locks into place.

 

 

Ice ’N Water dispenser

1. Locate light bulb inside top edge of dispenser frame. Unscrew to remove.

2. Replace light bulb with a 230 volt bulb no greater than 12 watts.

Hints and Care

How to Get the $ Most Out of

Your Energy Dollar

This refrigerator is designed to be one of the most energy efficient refrigerators available. Reduce energy use by observing the following.

Operate in normal household temperatures of 13° to 43°C away from heat sources and direct sunlight.

Set refrigerator, freezer, and Chiller Freshsystem controls no colder than necessary.

Keep freezer section full.

Keep door gaskets clean and pliable. Replace gaskets if worn.

Keep condenser coils clean.

17

Page 17
Image 17
Amana XRSS287BB, XRSS287BW manual How to Remove and Replace Light Bulbs, How to Get the $ Most Out, Your Energy Dollar