Amana XRSS287BW, XRSS287BB manual How to Install the Handles, How to Connect the Water Supply

Installing Your Refrigerator

How to Install the Handles continued

Stainless Steel Handles continued

5 Inserthole. screw plug into predrilled

To remove after initial install...

•Follow steps 2 through 5 in reverse order.

IMPORTANT: To avoid damage to unit, use a flat blade screwdriver edge wrapped in masking tape to remove screw plugs.

6Repeat steps 2 through 5 to install freezer handle.

How to Connect the Water Supply

• Contact a qualified engineer to perform this task.

How to Level Your Refrigerator

!CAUTION

•To avoid damage to walls and flooring, protect soft vinyl or other flooring with cardboard, rugs, or other protective material.

•To avoid damage or breakage to adjusting bolt, do not use power tools to correct leveling.

•DO NOT adjust unit to be any shorter than 173.9 cm tall (minus hinge and cap). Doing so may damage underside components.

Materials Needed

•	3/	" hex head driver	• Level
	8

1 Remove Toe Grille and

Bottom Hinge Covers

• Open both doors 180°, or as wide as possible, to remove.

2 Turn both front adjustment screws (A) clockwise to raise and counterclockwise to lower.

3 Turn both rear adjustment screws (B) clockwise to raise and counterclockwise to lower.

4Check with level to verify 6 mm tilt to the back for proper door closure.

•If unit is aligned and stable, replace toe grille.

What if my doors are not aligned?

•Locate the higher door, and turn front adjustment screw counterclockwise. Continue until doors are level.

•If bottom of adjustment range is reached, and doors are not level–raise opposite door by turning front adjustment screw clockwise.

•Replace toe grille

What if my unit rocks?

•Turn rear adjustment screw clockwise to raise rocking corner.

•Replace toe grille.

6