Amana XRSS287BB, XRSS287BW manual ICE Water

723,&￿		3266,%/(￿&$86(￿	Before Calling Service
ICE	WATER			62/87,21￿
Ice maker is not producing		Improper water valve was installed.		Check water connection procedure in your Installation
ice (some models-continued)				Instructions. Self-piercing and 3/16” saddle valves cause low
				water pressure and may clog the line over time. Amana is not
				responsible for property damage due to improper
				installation or water connection.
Unit is leaking water		Plastic tubing was used to complete water		Amana recommends using copper tubing for installation.
		connection.		Plastic is less durable and can cause leakage. Amana is
				not responsible for property damage due to improper
				installation or water connection.
		Improper water valve was installed.		Check water connection procedure in your Installation
				Instructions. Self-piercing and 3/16” saddle valves cause low
				water pressure and may clog the line over time. Amana is
				not responsible for property damage due to improper
				installation or water connection.
Ice forms in inlet tube to ice		Water pressure is low.		Water pressure must be between 20 to 100 pounds per
maker				square inch to function properly. A minimum pressure of 35
				pounds per square inch is recommended for units with
				water filters.
		Freezer temperature is too high.		See the controls section in your Owner’s Manual for
				assistance on how to adjust your controls. Freezer is
				recommended to be between 0 to 2°F (-18 to –17°C).
Water flow is slower than		Water pressure is low.		Water pressure must be between 20 to 100 pounds per
normal				square inch to function properly. A minimum pressure of 35
				pounds per square inch is recommended for units with
				water filters.
		Improper water valve was installed.		Check water connection procedure in your Installation
				Instructions. Self-piercing and 3/16” saddle valves cause low
				water pressure and and may clog the line over time.
				Amana is not responsible for property damage due to
				improper installation or water connection.
		Water inlet tubing has kinks.		Turn off water supply and remove kinks. If kinks cannot be
				removed, replace tubing.
		Water filter is clogged or needs to be		Change water filter.
		changed.
Dispenser water is not cold		Refrigerator has been recently installed		Allow approximately 12 hours for water in holding tank to
				chill.
		Water supply in holding tank has been
		depleted.
		Water has settle into water lines outside		Discard first glass of water and refill.
		holding tank and has warmed to room
		temperature.

21