DX4™

Controls and Features Cont.

Rear Panel

17

18

19

21

22

23

24

22

 

AMERICAN AUDIO

CAUTION

PREAMP MIXER

RISK OF ELECTRIC SHOCK

DO NOT OPEN

MODEL NO. DX-4

AVIS:RISQUE DE CHOC ELECTRIQUE-NE

AC 18V ~ 50/60HZ 20W

PAS OUVRIR.

 

25

26

27

28

29

30

31

17.POWER CONNECTION - This connector is used to supply main power to the unit via the included detachable power adaptor. Use only the supplied AC power adaptor. This cord is designed to fi t in one direction only. Do not attempt to force a cord in if it does not fi t, be sure the cord is being inserted properly

18.BALANCED XLR MASTER OUTPUTS - The Master Output includes a pair XLR Balanced JACKS as well as a pair RCA UNBALANCED JACKS (19). The 3-pin XLR jacks send a high current balanced output signal. These jacks should be used when you will be driving an amp or other audio equipment with a balanced input, or whenever you will be running a signal line greater than 15 feet. Always, use these jacks whenever possible.

19.RCA MASTER OUTPUTS - The Master Output includes a pair XLR BALANCED JACKS (18) as well as a pair RCA Unbalanced Jacks. The RCA jacks send a low current unbalanced output signal. These jacks should only be used for shorter cable runs to signal processors or looping to another mixer. For cable runs greater than 15 feet use the XLR BALANCED JACKS (18)

20.CHANNEL 4: LINE 6 INPUT JACKS - These Jacks are used for line level inputs. Connect CD players or Tape Decks to LINE inputs. Line level musical instruments with stereo outputs such as Rhythm Machines or Samplers should also be connected to LINE inputs. Turntables should only be connected to “Phono” inputs. The red colored RCA jack represents the right channel input and the white represents the left channel input. Input volume will be controlled by the channel four FADER

(4).

21.CHANNEL 3: LINE 4 INPUT JACKS - These Jacks are used for line level inputs. Connect CD players or Tape Decks to LINE inputs. Line level musical instruments with stereo outputs such as Rhythm Machines or Samplers should also be connected to LINE inputs. Turntables should only be connected to “Phono” inputs. The red colored RCA jack represents the right channel input and the white represents the left channel input. Input volume will be controlled by the channel three FADER

(4).

©American Audio® - www.americandj.com - DX4™ Instruction Manual Page 7

Page 7
Image 7
American Audio DX4 manual Rear Panel