American DJ Color 150/RG Fuse & Lamp Replacement, Color 150/RG Halogen Lamp Warning

- www.americandj.com - Color 150/RG™ Instruction Manual Page 14

©American DJ Supply®

Gobo Wheel Cover Thumb Screw

Gobo Wheel Cover

Gobo Wheel

Unit Bottom

Fan Plate Pro- tective Plate

This unit includes two interchangeable gobos. These gobo may substituted with any 26mm gobo (20mm viewable). A detailed list of available gobo for this unit may be found on the American DJ® web site, if you do not have access to the internet please contact customer support and request a catalog. To change the gobos;

1. Flip unit over so the bottom is facing up.

2. Remove the thumb screw on the rear panel of the unit and slide out the protective fan grill plate.

3. Removing the fan grill plate will expose an addition thumb screw that retains the gobo wheel protective cover. Remove this thumb screw and cover.

4. Once the gobo wheel is exposed, use a small flat head screw drive to gently push one end of the gobo wheel down. This will expose the opposite end of the gobo wheel, allowing you to remove a gobo and replace it with another.

5. Use a small flat head

screwdriver to remove the gobo retaining ring, this

will allow you to pop out the gobo.

6. Insert a new gobo and reassemble in reverse

order.

Color 150/RG™

Color 150/RG™ Fuse & Lamp Replacement

Caution: Always replace with the exact same type lamp and fuse, unless otherwise specified by an authorized American DJ® technician. Replacing with anything other than the specified part can damage the unit and will void the manufactures warranty.

Warning: If, after replacing the lamp or fuse either one continues to blow, STOP using the unit. Contact customer support for further instructions, you may have to return the unit for servicing. Continuing to use the unit may cause serious damage.

Fuse Replacement: Disconnect the unit’s main power supply. Insert a standard flat head screw driver in to the fuse holder housing. Turn the screwdriver in counter-clockwise direction to remove the fuse holder. Remove the fuse holder to expose the fuse. Remove the old fuse and discard it. Replace the fuse with the same type. Insert the fuse holder back into it’s housing and turn it in clockwise direction to lock the holder in place.

Lamp Replacement: Caution! Never attempt to change the lamp while the fixture is plugged in. Always disconnect the main power and allow the unit ample time to cool before attempting to replace the lamp. Lamp replacement has been made simple by incorporating the use of a flip-up top cover that is retained by a single thumb screw.

1.Be sure to follow the proper handling procedures that deal with halogen lamps. Never touch the new lamp with your bare fingers.

2.Remove the single thumb screw located on top of the unit. This screw holds the flip-up lamp socket assembly cover in place.

3.Flip-up the cover. The cover is on hinges and will not fall off.

4.Carefully remove the old lamp and discard it in the trash.

5.Replace the lamp with an exact match and reassemble.

Flip-Up Lamp Cover

Lamp/Socket Assembly

Thumb Screw Retaining Hole

Unit Top Cover

Color 150/RG™ Halogen Lamp Warning

Halogen Lamp Warning:

This fixture is fitted with a halogen lamp which is highly susceptible to damage if improperly han- dled. Never touch the lamp with your bare fingers as the oil from your hands will shorten lamp life. Also, never move the fixture until the lamp has had ample time to cool. Remember, lamps are not covered under warranty conditions.

Gobo Replacement

©American DJ Supply® - www.americandj.com - Color 150/RG™ Instruction Manual Page 13