K.Microprocessor controller (computer) will not accept any keyboard entries, i.e., L.E.D. (light emitting diode) display reads "FILL" and when keyboard entries are selected, the L.E.D. display continues to read "FILL"...
1.Failed keyboard label (touchpad) assembly.
2.Failed microprocessor controller (computer).
L.Microprocessor controller will only accept certain keyboard entries...
1.Failed keyboard label (touchpad) assembly.
2.Failed microprocessor controller (computer).
M.Microprocessor controller (computer) locks up and L.E.D. (light emitting diode) display reads erroneous message(s) or only partial segments...
1.Transient power voltage (spikes)...disconnect power to dryer, wait one (1) minute, and reestablish power to dryer. If problem is still evident ...
a.Failed microprocessor controller (computer).
b.Failed keyboard label (touchpad) assembly.
N.Dryer stops during a cycle and L.E.D. (light emitting diode) display returns to "FILL"...
1.Fault in microprocessor heat sensor circuit ...
a.Loose connection in wires between temperature sensor and microprocessor controller (computer).
2.Loose connection somewhere in main power circuit to microprocessor controller (computer).
O.No heat (for GAS MODELS ONLY)...ignitor glows, burner goes on and off right away...
1.Flame Probe out of adjustment...reposition closer to the flame area.
2.Sail switch is fluttering ...
a.Lint drawer/screen dirty.
b.Restriction in exhaust duct work.
3.Insufficient
4.Failed flame probe.
5.Failed Hot Suface Ignition (HSI) module.
6.Failed gas valve.
48
