American Dryer Corp ID-120

NOTE: ADC reserves the right to make changes in specifications at any time without notice or

obligation.

Specifications

IDG-120 (Gas)

IDS-120 (Steam)

Contents

Main ID-120 (Gas/HSI & Steam) Installation Manual Retain This Manual In A Safe Place For Future Reference Important ID-120 Page Page Table of Contents Page SECTION I IMPORTANT INFORMATION IMPORTANT: The dryer must be transported and handled in an upright position at ALL times. A. RECEIVING AND HANDLING B. SAFETY PRECAUTIONS Page Gas Steam SECTION II SPECIFICATIONS/COMPONENT IDENTIFICATION A. SPECIFICATIONS (GAS AND STEAM) Page B. COMPONENT IDENTIFICATION Page SECTION III INSTALLATION PROCEDURES A. LOCATION REQUIREMENTS IMPORTANT: The dryer must be installed on noncombustible floors only. IMPORTANT: Dryer should be located where a minimum amount of exhaust duct will be necessary. B. UNPACKING/SETTING UP IMPORTANT: The dryer must be transported and handled in an upright position at ALL times. C. DRYER ENCLOSURE REQUIREMENTS D. FRESH AIR SUPPLY REQUIREMENTS E. EXHAUST REQUIREMENTS Page Page Page Page F. ELECTRICAL INFORMATION ID-120 (Gas and Steam Only) ELECTRIC AL S ERVIC E SP EC IF I C ATI O N S (P ER DRY ER) Page G. GAS INFORMATION TYPE OF GAS NATURAL LIQUID PROPANE TYPE OF GAS Page Page H. STEAM INFORMATION OPERATING STEAM PRESSURE Page COMP RESSED AIR SUPPLY AIR PRESSURE Normal 80 PSI 5.51 bars Minimum Supply 70 PSI 4.82 bars Maximum Supply 90 PSI 6.21 bars Page I. COMPRESSED AIR J. PREPARATION FOR OPERATION/START-UP COMP RESSED AIR SUPPLY AIR PRESSURE Normal 80 PSI 5.51 bars Minimum Supply 70 PSI 4.82 bars Maximum Supply 90 PSI 6.21 bars K. PREOPERATIONAL TESTS Page Page L. OPERATING INSTRUCTIONS M. SHUT DOWN INSTRUCTIONS SECTION IV SERVICE/PARTS INFORMATION A. SERVICE B. PARTS SECTION V WARRANTY INFORMATION A. RETURNING WARRANTY CARDS B. WARRANTY C. RETURNING WARRANTY PARTS Page SECTION VI ROUTINE MAINTENANCE A. CLEANING Page Page SECTION VII REVERSING TIMER SPIN/DWELL ADJUSTMENTS TIMING LEGEND SECTION VIII Page Page Page I M P O R T A N T MANUAL RESET HI-LIMIT INSTRUCTIONS FOR PHASE 7 MODELS SECTION X BURNER AND BASKET (TUMBLER)/LINT CHAMBER MANUAL RESET HI-LIMIT INSTRUCTIONS IMPORTANT