4.Steam Damper Air System Connections
This dryer is manufactured with a pneumatic (piston) damper system, which requires an external supply of compressed air of 0.75 CFH. The air connection is made to the steam damper solenoid valve, which is located at the rear of the top console.
a. Air Requirements
COM PRESSED | AIR PRESSURE | ||
AIR SUPPLY | |||
|
| ||
|
|
| |
Normal | 80 PSI | 5.51 bars | |
|
|
| |
Minimum Supply | 70 PSI | 4.82 bars | |
|
|
| |
Maximum Supply | 90 PSI | 6.21 bars | |
|
|
| |
Shaded areas are stated in metric equivalents
b.Air Connection
Air connection to system
c.No air regulator or filtration is provided with the dryer. External regulation/filtration of 80 PSI (5.51 bars) must be provided. It is suggested that a regulator/filter gauge arrangement be added to the compressed air line just before the dryer connection. This is necessary to insure that correct and clean air pressure is achieved.
5.Steam Damper System Operation
The steam damper, as shown in the top illustration (Diagram 1) on page 30, allows the coil to stay constantly charged eliminating repeated expansion and contraction. When the damper is opened, the air immediately passes through the already hot coil, providing instant heat to start the drying process. When the damper is closed, ambient air is drawn directly into the basket (tumbler), allowing a rapid cool down.
Diagram 1 shows the damper in the heating (open) mode, allowing heat into the basket (tumbler).
Diagram 2 shows the damper in the cool down (closed) mode, pulling ambient air directly into the basket (tumbler) without passing through the coils.
NOTE: With the dryer off or with no air supply, the steam damper is in cool down mode as shown in Diagram 2 (refer to the illustration on the following page).
29
