3.If more headroom is needed when moving dryer into position, the top console (module) may be removed. a. To Remove Top Console (Module)
1) Disconnect the ground wire (A) at the Rear Upper Left Hand Corner of Dryer.
2) Remove the eight (8) set of nuts and washers (B) holding the console (module) to base.
3) Disconnect the white plug connector (C) located on the top of the rear electric service/ relay box (provides power to the heat circuit).
4) Disconnect air connection from the
5) Lift the console (module) off of the dryer base.
IMPORTANT: The dryer must be transported and handled in an upright position at all times.
4.Exhaust Duct Work
NOTE: ATransition Piece for the exhaust is shipped inside the tumbler (basket). This Transition Piece is for locations with round exhaust duct work.
a. To install the Transition Piece, align the four (4) clinch studs into the four (4) clearance holes on the dryer.
b. Using the four (4) free spin wash nuts (included with the Transition Piece), tighten the wash nuts on to the clinch studs which will secure the Transition Piece to the dryer.
c. The round duct can now be connected to the dryer.
12
