SECTION III
INSTALLATION PROCEDURES
Installation should be performed by competent technicians in accordance with local and state codes. In the absence of these codes, the installation must conform to applicable American national Standards: National Electrical Code ANSI/NFPA NO.
A. LOCATION REQUIREMENTS
Before installing the dryer be sure the location controls to local codes and ordinances. In the absence of such codes or ordinances the location must conform with the National Electrical Code ANSI/NFPA NO. 70- LATEST EDITION, or in CANADA, the Canadian Electrical Codes Parts 1 & 2 CSA
1.The dryer must be installed on a sound level floor capable of supporting its weight. It is recommended that carpeting be removed from the floor area that the dryer is to rest on.
2.The dryer must not be installed or stored in an area where it will be exposed to water or weather.
3.The dryer is for use in noncombustible locations.
4.Provisions for adequate air supply must be provided as noted in this manual. Refer to Fresh Air Supply in section D.
5.Clearance provisions must be made from combustible construction as noted in this manual. Refer to Dryer Enclosure Requirements in section C.
6.Provisions must be made for adequate clearances for servicing and for operation as noted in this manual. Refer to Dryer Enclosure Requirements in section C.
7.Dryer must be exhausted to the outdoors. Refer to Exhaust Requirements in section E.
8.Dryer must be located in an area where correct exhaust venting can be achieved as noted in the manual. Refer to Exhaust Requirements in section E.
IMPORTANT: Dryer should be located where a minimum amount of exhaust duct will be necessary.
9.Provisions must be made for an adequate air supply to be brought to the dryer. Refer to make up air requirements on page 12.
9
